Pneumatics, cooling, air preparation and temperature control — from a single component to a whole line. Below: the areas we work in and how a project runs.
Every so often we take one product off the shelf and explain how to read it, when to choose it and what to swap it with.
Components from stock — but also the whole solution: design, supply and commissioning.
Mould cooling loops, hydraulic and compressor cooling, server rooms and control cabinets. Chillers, heat exchangers, pump sets — sized to the real heat load.
FRL units, dryers, condensate drainage, pressure control. Clean, dry air before it ruins the pneumatics.
Sensors, controllers, heating/cooling loop control. So process temperature is repeatable, not guesswork.
Cylinders, valves, vacuum, sequence control and electro-pneumatics — from a single assembly to a whole line.
Custom brackets, adapters and plates to drawing or sample — machined at a CNC shop in Rīga.
Send a code, a size, a sketch or just a description — a photo of the machine works too. We work out what actually needs solving.
We propose the components or solution with a spec and a lead time. If a cheaper equivalent fits — we say so.
From Rīga stock in 24 h or the EU warehouse in a few days. If needed — installation and commissioning.
We test it in operation and leave a diagram and a spare-parts list, so nothing’s guesswork later.
Send a description, a size or a photo of the machine — we usually reply the same day.
